How to Install the Instant Boiling Water System?

- Apr 18, 2018 -

Follow this step-by-step installation, guide to install your new instant boiling water system easily. You will find the following items in your package,you will need the following tools and accessories for assembly.


图片1.JPG



Step 1 Installing the faucet first

Take off the metal gasket and rubber from the bottom of the faucet, and screw the nut and adaptor from right to left.

Then insert the hoses through the hole in the sink for the faucet, hold the faucet in this position and fit on the metal gasket and rubber, screw the nut and adaptor to fixed the faucet.

图片2.JPG


Next screw the shorter stainless steel pipe into the filter water inlet hole, similarly, screw the longer stainless steel pipe into the hole the filter water outlet hole.

Lastly, screw the 1/2 water hose into the hot water hole, and screw the other 1/2 water hose into the cold water hole, making sure you screw the hoses to the maximum.

Finally, connect a 1/4 adaptor with a 6.4mm push fit tube, and then insert into the longer stainless steel pipe. In the same way, connect a 1/4 adaptor with a 6.4mm push fit tube and insert into the short stainless steel.

Please check against the installation instructions make corrections.



Step 2 Mounting the Tank

There are every part of tank as below:

图片3.JPG


These are fittings of tank:

图片4.jpg


Before mounting the tank, please make sure the dial on the body of tank stays at OFF position.

First, please put the O-ring into the water pipe.

图片5.jpg

图片6.jpg 


Use a wrench to hold the water pipe to make sure that the water pipe will not be damaged. We should hold the water pipe with wrench until tighten the nut to the maximum.

图片7.jpg

Use a wrench to hold the water pipe to make sure that the water pipe will not be damaged. We should hold the water pipe with wrench until tighten the nut to the maximum.


Step 3 Connecting the Faucet to the Tank

图片8.jpg

Connect the 6.4mm push fit tube (filter water outlet tube) and clear silicon hose (steam hot water hose) onto the corresponding, fitting on the tank , push the tube and clear silicon hose down until it clicks into place.

Next, connect the 6.4mm push fit tube (filter water inlet tube) onto the filter.


Step 4 Final Water Connect

Respectively connect the 1/2 tube onto the existing cold water valve and hot water valve. Finally, make the cold water valve in contact with the filter with a 1/2 tube.


Remarks: It is recommended that the filter is changed every six or eight months in order to prevent any issue with water flow, lime scale and water debris built up.

For more information about the instant boiling water system and many other products within the Springking range, please browsed through our website www.skfirm.com, we are always at you service.





Related Industry Knowledge

Related Products

  • Alkaline Water Filter System with Acid Brass Chromed Faucet for Ionizer Dispenser
  • Drinking Alkaline Water Purifier Ionizer Machine with Small Faucet
  • Filtered Osmosis Reverse Water Faucets Stainless Steel Purifier Kitchen Sink Two Way Drinking Taps
  • Stainless Steel Watersense Filter Faucets with Sprayer Pull Out Brass Material Kitchen Drinking Taps
  • Filtered Cold Water Dispenser Tap Pureflow Water Purifier Residential Water Filter Bridge Faucet
  • Commercial 3 Way Kitchen Tap Cabinet Water Filters Water Saving Faucet for Sale